Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Memorial Homeowners
A broken spring is why your garage door suddenly won’t lift, feels impossibly heavy, or stops halfway with a bang. In Memorial, where most homes were built with two-car garages and doors that get used several times a day, spring failure is the single most common reason a door quits. We specialize in garage door spring repair and nothing else, so we diagnose the actual failure before touching a winding cone. Our technicians have up to 11 years of experience with torsion and extension systems on the brands this neighborhood actually has installed. We answer 24/7, and when you call (877) 492-2056 we can often get a technician out the same day.
What Our Garage Door Spring Repair Service Includes
Torsion Spring Replacement
A torsion spring is the coil mounted on the shaft above your door, and it carries the entire weight of the panels through a cable drum on each side. When it breaks, the door becomes dangerously heavy and the opener alone can’t safely lift it. We replace the spring with a correctly sized one matched to your door’s weight, then reset the cable tension and balance the door before we leave. Getting the wire gauge and cycle rating right matters: an undersized spring fails early, and an oversized one overloads the opener and the hinges.
Extension Spring Replacement
Extension springs run along the horizontal tracks on each side and stretch as the door closes, which is the older setup you’ll still find on plenty of Memorial homes. They fail differently from torsion springs: when one lets go, it can travel, which is why a safety cable through the center of the spring is essential. We replace extension springs in matched pairs so the door stays level, and we install or renew the safety cables at the same time. If your door has two springs and only one is broken, replacing both now saves you a second service call later.
Broken Spring Repair
The telltale sign of a broken spring is the door opening a foot and stopping, or a loud snap you heard from inside the house. Sometimes the spring breaks cleanly in two and you can see the gap; other times it’s a hairline crack you’d miss without measuring coil gaps and testing tension. We confirm the break, check for related damage to cables, drums and the bottom bracket, and explain what needs replacing before any work starts. A snapped spring often takes a roller or a bent track with it, so a proper repair covers the whole system, not just the coil.
Spring Adjustment
Sometimes a spring isn’t broken, just out of balance: the door drifts down on its own, feels heavy at the halfway point, or the opener strains to close it. We adjust the tension to bring the door back into balance so it holds position when you let go halfway up. On torsion systems this means carefully resetting the winding, which is the step that most injures homeowners who try it themselves. A balanced door also takes load off the opener motor and extends its life.
Safety Cable Installation
Safety cables thread through the center of an extension spring so that when the spring breaks, the pieces stay contained instead of flying across the garage. If your door has extension springs without cables, that’s a real hazard, and adding them is straightforward. We install cables rated for the spring load and anchor them properly at both ends. Homes with torsion springs are protected differently by the shaft and drums, but the principle is the same: contain the stored energy so a failure stays a repair, not an injury.
Spring Inspection
A spring inspection checks coil condition, wire gauge, cycle wear, cable condition and door balance all at once, so you know what’s wearing out before it fails. Springs are rated in cycles, and a door used four times a day uses up that rating faster than one opened twice. We measure, test the balance, and tell you honestly whether you have months left or need to plan a replacement now. It’s the least expensive part of spring service and the one that prevents the most inconvenient breakdowns.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
Springs don’t care what name is on the door, but the door’s weight, track geometry and drum setup absolutely do, and those vary by manufacturer. We work on Clopay doors regularly and know how their panel weights and track designs affect spring sizing. The same goes for LiftMaster and Chamberlain opener systems, which we service alongside whatever torsion or extension setup is carrying the door, so the opener and the spring get evaluated together rather than in isolation. If your opener is straining because the spring is failing, fixing one without checking the other just moves the problem.
We also service Genie systems and the mechanical door brands common across Memorial homes, and our approach is the same on every one: measure the door, match the spring, and test the balance before calling the job done. We’re not a dealer pushing a particular make. Whether you have Clopay, LiftMaster, Chamberlain, Genie or any other make, we can help, using the right spring for the door you actually own.
Signs You Need Garage Door Spring Repair Right Now
- The door opens a few inches and stops. This is the classic broken-spring symptom: the opener lifts until it meets the full weight of the door, then the safety reverse kicks in. Stop using the opener when this happens, because repeated attempts can burn out the motor.
- You heard a loud bang from the garage. A torsion spring breaking sounds like a gunshot and often shakes the house. Even if the door still works, that noise usually means a coil has snapped or a cable has failed.
- The door feels extremely heavy when you lift it by hand. A properly balanced door lifts with one hand and stays put halfway up. If you have to muscle it, the spring has lost tension or broken, and the door is a falling risk.
- The door hangs crooked or one side sags. An uneven door usually means one spring in a pair has failed or stretched unevenly. Running it this way twists the panels and wears the tracks.
- Visible gaps or stretched coils. Look at the spring above the door (from the floor, never up close) for a clean break or a gap between coils. On extension springs, look for a stretched section or a spring that’s lost its shape.
Our Garage Door Spring Repair Process – Step by Step
- 1
We diagnose before we quote. We check the spring type, test the door balance, and inspect cables, drums, rollers and the bottom bracket. That tells us whether it’s a single spring, a pair, or a related failure that would undo a spring-only fix.
- 2
We give you a written price up front. You get the estimate in writing before any work starts, covering the springs and anything else that needs replacing. Nothing gets added later without your say-so.
- 3
We secure the door and release the stored energy. Both torsion and extension springs hold serious force, so we clamp the door, relieve tension with the right winding bars, and only then remove the old spring. This is the step that makes spring work a professional job.
- 4
We install matched springs and set the balance. New springs go in as a matched set, cables and safety cables get checked or renewed, and we wind the tension to the door’s actual weight. Then we test the balance by hand at the halfway point.
- 5
We run the door and confirm the fix. We cycle the door several times, check that the opener’s force and travel settings are correct, and walk you through what we replaced. You see the door working smoothly before we pack up.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Memorial?
Garage door spring repair in Memorial typically runs $180 – $340 for one spring, including the spring and the labor to install and balance it. A matched pair is usually replaced together, so a pair costs about twice that range. That’s the honest way to price it: springs are sold and installed per spring, and quoting one number for both would only mislead you. Cable repair, which often comes up alongside a broken spring, runs $130 – $250.
| Service | Typical estimated range |
|---|---|
| Torsion or extension spring repair (one spring) | $180 – $340 |
| Matched pair of springs | About twice the single-spring range |
| Cable repair | $130 – $250 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
What moves the price within that range: the spring type, the wire gauge and cycle rating you choose, whether it’s one spring or a pair, and whether related parts like cables or rollers need replacing at the same time. How to avoid overpaying is simple. Ask for the price in writing before work starts, ask whether both springs are being replaced and why, and ask what cycle rating the new spring carries. A free estimate from us covers the diagnosis, the written price, and a plain answer on whether you can safely wait. The written estimate sets the final price, and we confirm it with you before anyone touches the door.
Garage Door Spring Repair Near Memorial – Our Service Area
We cover Memorial and the surrounding neighborhoods, including Uptown, Oak Forest, Brays Oaks, Garden Oaks, Westbury, Braeswood, River Oaks, Bunker Hill Village, Westchase, Hedwig Village and the Energy Corridor. If you’re in one of those areas, we can usually schedule a garage door spring repair visit the same day you call. Homeowners closer to Oak Forest can also read our garage door spring repair page for that area, or start with our main Garage Door Repair Memorial page.
Serving Memorial, TX – Our Local Coverage Area
We serve Memorial and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Memorial
Garage door spring repair is the replacement or adjustment of the torsion or extension springs that counterbalance your door’s weight. Those springs carry most of the load, so when one fails the door becomes too heavy for the opener and unsafe to lift by hand. The repair means installing a correctly sized spring, setting the tension, and confirming the door is balanced. It’s a high-risk job because the springs hold stored energy, which is why we handle the winding and release with proper tools.
Most single-spring replacements take about an hour to ninety minutes once we’re on site, and a matched pair takes a little longer. Add time if cables, rollers or a bent track need attention at the same visit. We diagnose first and tell you the expected time before we start, so you’re not guessing. If the job turns out bigger than expected, you’ll hear why and approve the price before we continue.
Spring repair in Memorial typically runs $180 – $340 for one spring, and a pair is usually about twice that because both are replaced together. Cables and rollers, if they need replacing, add their own line items to the written estimate. The written estimate sets the final price, and we confirm it with you before any work starts. Call (877) 492-2056 for an exact quote – estimates are free.
Yes. We service LiftMaster and Chamberlain systems, and we check the opener whenever we do spring work, because a failing spring strains the motor and its force settings. If your opener has been struggling against a heavy door, we’ll test its travel and force limits as part of the visit. We also work on Genie and Craftsman opener platforms. One specialist handles the spring, the opener and the parts, so you’re not coordinating between companies.
Same-day service is often available when you call, and we answer 24/7 so you can reach us whenever the door fails. Dispatch runs 7am to 7pm, Sunday through Friday, and we’re closed Saturday; a call outside dispatch hours is booked into the next opening. Call (877) 492-2056 and we’ll tell you the soonest we can get a technician to your door. For the fastest visit, have your door’s weight and spring type ready if you know them.
We’ll explain exactly what’s covered on your specific spring before we install it, since coverage depends on the spring type and cycle rating you choose. We don’t hide the terms in fine print or promise more than the part allows. Ask us during the estimate and we’ll put the details in writing. Higher-cycle springs generally last longer between replacements, so it’s worth asking which option fits your door.
Clear the floor area under and around the door, and keep cars out of the garage so we have room to work safely. Don’t try to lift or cycle the door once a spring has broken; leave it closed until we arrive. If you know the door’s brand or have the opener manual, have it handy. Then just call (877) 492-2056 with your address and we’ll set up a time within dispatch hours.
Schedule Your Garage Door Spring Repair Service in Memorial Today
A broken spring won’t fix itself, and running the opener against it only adds wear. Call (877) 492-2056 to book garage door spring repair in Memorial. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. You get a free, no-obligation written estimate before any work begins. We also handle Garage Door Repair and Garage Door Parts if something else needs attention.
Written by the team at Garage Door Repair Memorial.